Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help assembling clutch
02-18-2014, 10:45 AM
Post: #1
Help assembling clutch
1992 Porsche 911, G50/03 transmission, southern Georgia. I'm assembling the clutch on this transmission, and I need some advice about installing the assembled pressure plate/release bearing. I'm accustomed to seeing the release bearing attached to the clutch fork, which it is not on this transmission. There are two ears on the release bearing that it would seem are engaged by the arms of the fork, but it seems to me that the release bearing would be spinning, and when I pressed the clutch pedal, the spinning ears would bang into the stationary fork arms. Any advice on proper assembly would be very much appreciated.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Help assembling clutch - dwafford - 02-18-2014 10:45 AM
RE: Help assembling clutch - Rupe - 02-18-2014, 10:21 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)