Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
07 ford f150 xl clutch issue
02-18-2014, 06:45 PM
Post: #1
07 ford f150 xl clutch issue
Hey all,

Like the subject says I have an f150 xl standard trans. About 60000 miles on it. My father in law was towing a 70s dodge ram with it a few months back (it is his rig), and when trying to back it into place ran the clutch into the ground to where you could shift it when it was off, but when you started the car the clutch would not disengage to shift. So I put a new clutch kit on there. It being my first time doing it I followed the directions. the clutch kit came with only the two plates and the alignment tool. after I put everything back together there was still the same issue. bled the slave cylinder and on the side of this transmission it had a window to see the slave cylinder working when the hydraulic hose was back on and there was plenty of pressure in the pedal, but still would not disengage the clutch. Transmission is off again to make sure i installed the clutch plate the correct way, I did, and that I didnt bend the shaft when putting the transmission back in. Everything I see looks like I installed it correctly. The pilot bearing looks good, and the fly wheel has minimal heat discoloration. Can the slave cylinder go bad without it leaking? the fluid in the slave tank was full after the clutch went bad. Any help or tips would be great.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
07 ford f150 xl clutch issue - npomme - 02-18-2014 06:45 PM
RE: 07 ford f150 xl clutch issue - Rupe - 02-18-2014, 10:32 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)