Thread Closed 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
93 cavalier wont shift
03-07-2007, 09:00 AM
Post: #1
93 cavalier wont shift
could someone give me a little info . i'm stuck ! i just had a new clutch kit put in and new clutch cables put in.but the car still wont move, it feels like it's going into gear but it just wont move.i was told that it need a new clutch. the padle went to the floor before now it feels fine but wont move
Find all posts by this user
03-07-2007, 05:47 PM
Post: #2
RE: 93 cavalier wont shift
Who but the new clutch in? When you said clutch cables are you referring to the shift cables? The clutch release system is hydraulic. It may need bleeding or the clutch master maybe bad. This may cause the trans not to go into gear. If it is going into gear and the clucth disc and pressure plate are working properly, but it still does not move. It would have to be trans internal or axles. Does the trans grind going into gear? Does it make any noise when you release the clutch?

Cary Joe York
Support
Find all posts by this user
03-08-2007, 11:41 AM
Post: #3
RE: 93 cavalier wont shift
CaryJoeYork Wrote:Who but the new clutch in? When you said clutch cables are you referring to the shift cables? The clutch release system is hydraulic. It may need bleeding or the clutch master maybe bad. This may cause the trans not to go into gear. If it is going into gear and the clucth disc and pressure plate are working properly, but it still does not move. It would have to be trans internal or axles. Does the trans grind going into gear? Does it make any noise when you release the clutch?

auto shop installed the new clucth kit.yes i am referring to the shift cables(both new).they said they bled it 4 times,new master , new slave.whole new clutch system .yes it goes into gear without making any noises,they said that they cant find the problem.i have all this money in this car and i am still in the same spot. any info
Find all posts by this user
03-09-2007, 12:09 AM
Post: #4
RE: 93 cavalier wont shift
If it is going into gear and the clucth disc and pressure plate are working properly, but it still does not move. It would have to be trans internal or axles.

Cary Joe York
Support
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)