Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1994 Lincoln Town Car Remove interior door trim
08-20-2011, 09:26 PM
Post: #1
1994 Lincoln Town Car Remove interior door trim
Hi,
My drivers side window doesn't go up and I need to remove the trim to get at the switch or wiring. Can someone advise me on the steps to remove the interior door trim?
Thanks so much,
Tony
Find all posts by this user
Quote this message in a reply
08-21-2011, 03:43 PM
Post: #2
RE: 1994 Lincoln Town Car Remove interior door trim
See if this helps any. It is from the service manual.

Trim Panels, Door

Front

Town Car

The following procedure must be used during removal and installation of the door armrest and trim panel. Refer to the appropriate illustrations for component and vehicle model identification.


Removal

CAUTION: To avoid breakage of door pull cover(s), insert a screwdriver diagonally between pull strap and chrome bracket. Snap out both sides then remove.

Snap out two door pull strap retaining screw covers. Remove screws.
Remove two screws on front and rear side of front door trim panel.
Using the Trim Pad Removing Tool, pry the trim panel retaining clips from the door inner panel.
NOTE: Do not use front door trim panel to remove trim clips from door inner panel. Replace any bent, damaged or missing push pins.

Remove window regulator control switch housing from back of front door trim panel . Lift up housing, remove retaining screws and disconnect all connectors.
Disconnect driver seat regulator control processor switch (driver door only) if equipped.
Twist out interior lamp wire assembly and remove the front door trim panel.

Installation

Ensure plastic watershield is secured to door panel.
Position front door trim panel to door. Connect interior lamp wiring.
Position the window regulator control switch housing and connect switch connectors.
Connect driver seat regulator control processor (14C708) (driver door only) if equipped.
Align door lock side to its mating slide on the sheet metal (front doors only)
Snap in front door trim panel . Ensure all retainers fit properly.
Install two retaining screws on front and rear side of front door trim panel .
Install two retaining screws and pull strap covers.


.gif  lincoln door panel.gif (Size: 22.93 KB / Downloads: 6)

Being way2old is why I need help from younger minds.



[Image: crybaby.jpg]
Find all posts by this user
Quote this message in a reply
08-21-2011, 03:53 PM
Post: #3
RE: 1994 Lincoln Town Car Remove interior door trim
(08-20-2011 09:26 PM)pontet Wrote:  Hi,
My drivers side window doesn't go up and I need to remove the trim to get at the switch or wiring. Can someone advise me on the steps to remove the interior door trim?
Thanks so much,
Tony

Thanks so much
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)