Thread Closed 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ignition lock cylinder
08-09-2007, 01:29 AM
Post: #1
ignition lock cylinder
does anyone know how to replace an ignition lock cylinder in a 1998 jetta?
Find all posts by this user
08-11-2007, 12:26 AM
Post: #2
RE: ignition lock cylinder
You must first remove the lock cyl housing pictured below.


Attached File(s)
.gif  79094371.gif (Size: 4.17 KB / Downloads: 11)

Cary Joe York
Support
Find all posts by this user
08-11-2007, 12:27 AM
Post: #3
RE: ignition lock cylinder
Then next step.

- Mark steering lock housing for hole at intersection of points -a- and -b-.
Dimension -a- = 12 mm (15/32 in.)
Dimension -b- = 10 mm (25/64 in.)

- Drill 3 mm (1/8 in.) diameter hole into steering lock housing at mark until lock cylinder stop spring is visible.
Hole depth: approx. 3 mm (1/8 in.)

- Compress stop spring using opposite end of drill and pull out lock cylinder.

Cary Joe York
Support
Find all posts by this user
08-11-2007, 12:28 AM
Post: #4
RE: ignition lock cylinder
To reinstall.

Installing

- Insert lock cylinder into steering lock housing.
- Insert key into lock cylinder.
- Push lock cylinder fully into housing while gently turning key.

Cary Joe York
Support
Find all posts by this user
08-11-2007, 12:30 AM
Post: #5
RE: ignition lock cylinder
Here is a diagram of the steering column. #15 is the lock cyl and #13 is the housing.


Attached File(s)
.gif  79101460.gif (Size: 9.2 KB / Downloads: 2)

Cary Joe York
Support
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)