Thread Closed 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Updated question on 1994 Isuzu Rodeo
01-23-2008, 05:41 PM
Post: #1
Question Updated question on 1994 Isuzu Rodeo
Well, I found a wire wich I am pretty certain, as well as the transmission shop is certain when I described it to him, that it was an O2 sensor. I tried the AutoZone website for info on where it goes and how to hook it back up without having to drive 40miles back to the shop and it does not have anything on that site on where it connects. Does anyone have an idea on where else I could look? The shop can't get my car back in today to re-hook it. I have to wait a couple of days. I really appreciate all the help. [/php]
Find all posts by this user
01-23-2008, 11:21 PM
Post: #2
RE: Updated question on 1994 Isuzu Rodeo
If you have the harness end of the wire (with the connector still on it) then you are looking for something about the size of a spark plug that is screwed into the exhaust pipe. That little gadget should have the mating plug dangling from it. Push hard till you feel / hear a click and you should be back in business.

BTW, that situation should have turned the check engine light on and set a code in the computer.

When you get it reconnected the check engine light may not go out right away. In some cars it takes many hot cold cycles or a scan tool to turn it off.

Rupe
Find all posts by this user
01-24-2008, 12:11 AM
Post: #3
RE: Updated question on 1994 Isuzu Rodeo
Here is a picture of a O2 sensor. The connector is somewere on top of the trans bell housing I believe.


Attached File(s)
.gif  62626995.gif (Size: 3.42 KB / Downloads: 1)

Cary Joe York
Support
Find all posts by this user
Thread Closed 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)